Need help installing our VPN on another device? Check out our: VPN for Windows, VPN for MAC, VPN for iOS, VPN for Android, VPN Router, and our VPN Chrome Extension. Once you are done, you can check your location by clicking here. The correct configuration should look similar to the screen below. Please check your interfaces and routing table again.Status should appear as connected once you click Apply.If in case you need any assistance please contact SaferVPN Live Chat Support) (Please Note : SaferVPN do not support IP address, it only offers HostName.
Please refer How to find SaferVPN server IP. Now click on the + sign and select OVPN Client.Ĭonnect To: Choose any server IP or hostname from one of the SaferVPN servers. Then click on the PPP tab on the left-side menu.
To configure a dhcp server on a Mikrotik router, click on IP>dhcp server>dhcp setup and follow through. Without a dhcp server, assignment of IPs can become a fulltime job, and if not properly done, there will IP conflicts. In most cases, a dhcp server will be required to help lease out IP addresses to connected users.
To configure a default route on Mikrotik, click on IP> route> enter gateway to destination 0.0.0.0/0 The router must be assigned a default gateway, also known as default route, to get to destinations beyond the ISP’s network. To assign an IP address manually, click on IP>address>add>enter address and subnetmask. See here for how to configure a Mikrotik router interface as a dhcp client. If the ISP has dhcp enabled, then the ether1 on the Mikrotik can be configured as a dhcp client, otherwise, an IP will be configured manually. In most cases, the ISP connection goes to ether1 while the LAN connection is plugged to ether2.
Before the assignment of IPs, the WAN and LAN interfaces must have been chosen.
To set system password, click on system>password>leave the space for old password blank and enter new password twice.Īt the most basic level, two IPs are required on the router to successfully connect users behind a Mikrotik router to the internet. To change username, click on system>users>double click on the admin user and change username from admin to something else. Users are advised to change these settings. Mikrotik routers have default username as admin with no password. Though not compulsorily required to connect a router to the internet, it highly recommended for the security of your network and network device. system identity set name=timigate Username and password To assign a Mikrotik router an identity, simply enter the commands below. It allows an administrator easily identify a router. This is not part of the requirement to connect a router to the internet but is recommended especially when managing multiple routers. Configuring system identity is part of the administrative configuration and is not compulsory. System Identity is to Mikrotik what hostname is to Cisco. How to configure a Mikrotik router System Identity These tasks, some of which are not compulsory, are listed below and will be looked into one after the other. There are seven basic configuration requirements that must be met on a Mikrotik router to provide internet access to all connected users.